Most casting cost is decided on the drawing board. These ten guidelines come up in almost every DFM review we do for US customers.
1. Keep wall thickness uniform
Sudden changes in section cause shrinkage porosity at the heavy section. Core out thick bosses and use ribs instead of solid mass.
2. Add draft to every wall
Permanent molds and die-casting dies need 1–3° draft on external walls and more on internal walls. Specifying zero draft forces machining.
3. Use generous fillets
Sharp internal corners concentrate stress and cause hot tears. A fillet radius of at least the wall thickness is a good start.
4. Think about the parting line early
Placing the parting line on a flat plane simplifies tooling and keeps flash away from sealing faces.
5. Define casting datums
Give the foundry datum targets on as-cast surfaces so the machine shop can locate the part repeatably.
6. Machine only what you must
Every machined surface adds machining stock, cycle time and porosity risk. Leave non-functional surfaces as cast.
7. Specify realistic tolerances
Use ISO 8062 casting tolerance grades or a general casting tolerance block, and tighten only functional features.
8. Choose the alloy for the process
A356 is excellent for gravity and low-pressure casting; A380 and ADC12 are designed for die casting. Specifying the wrong alloy for a process raises cost and scrap.
9. Avoid deep, narrow pockets
They are hard to fill, hard to cool and hard to clean. Open them up or use cores.
10. Talk to the foundry before freezing the design
A 30-minute DFM call before tooling is the cheapest cost reduction you will ever get. Send us your 3D model for a free review.
